FPV NEO-M8N GPS amp Compass Support DJI Naza M V1 and V2 Lite Flight Controller

FPV NEO-M8N GPS amp Compass Support DJI Naza M V1 & V2 Lite Flight Controller. A new generation GPS NEO-M8N, with low power consumption and high precision, the ultimate accuracy is 0.6 meters, actually almost 0.9 meters, greater than the previous generation NEO-7N 1.4-1.6 meters accuracy, support GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1 protocol, and mode or more.

Using 32-bit processor, compatible with NAZA M V1 & V2 flight controller, incomparably superior to 8-bit processor. Please take notice of the arrow on GPS, which stands for the head of a flyer. Similar calibration and usage with GPS. Coming with soft silicone gel cable 30cm. For softness, black rubber was wrapped on a surface. (Notice: black cable= GND, white cable=TX, yellow cable=RX, red cable=5V, 3.3-7.5V is ok), Metal foil label has been mounted on the bottom of GPS to reduce signal interference from other electronic types of equipment

Calibration Method:

1. Assistance AssistNow GNSS Online.
2. AssistNow GNSS Offline (up to 35 days)3.
3. AssistNow Autonomous (up to 6 days).
4. OMA SUPL & 3GPP compliant.
5. Oscillator TCXO (NEO-M8N/Q).
6. Crystal (NEO-M8M).
7. RTC crystal Built-In.
8. Noise figure On-chip LNA (NEO-M8M). Extra LNA for.
9. Lowest noise figure (NEO-M8N/Q).
10. Anti-jamming Active CW detection and removal. Extra.
11. Onboard SAW bandpass filter (NEO-M8N/Q).
12. Memory ROM (NEO-M8M/Q) or Flash (NEO-M8N).
13. Supported antennas Active and passive.
14. Odometer Travelled distance.
15. Data-logger For position, velocity, and time (NEO-M8N).
16. RoHS compliant (lead-free).
17. Manufactured and fully tested in ISO/TS 16949 certified production sites.
18. Uses M8 chips qualified according to AEC-Q100.
19. Supply voltage 1.65 V to 3.6 V (NEO-M8M).
20. Power consumption 4 23 mA @ 3.0 V (continuous).
21. 5 mA @ 3.0 V Power Save Mode.
22. (1 Hz, GPS mode only).
23. NEO-M8N-0 M8 Concurrent GNSS LCC Module.
24. TCXO, flash, SAW, LNA.
25. Time pulse Configurable 0.25 Hz to 10 MHz.
26. Using 32-bit processor, compatible with DJI NAZA LITE V1 & V2 flight controller, incomparably superior to the 8-bit processor.
27. Please take notice of the arrow on GPS, which stands for the head of the flyer.
28. Similar calibration and usage with DJI GPS.
29. Coming with soft silicone gel cable 30cm.
30. For softness, black rubber was wrapped on the surface.
31. (Notice: black cable= GND, white cable=TX, yellow cable=RX, red cable=5V, 3.3-7.5V is ok).
32. Metal foil label has been mounted on the bottom of GPS to reduce signal interference from other electronic equipment.

Specifications :-