ATMEGA16A – AU Microcontroller – (SMD Package) – TQFP – 44 Pin Microcontroller

The ATMEGA16A is a low-power CMOS 8-bit microcontroller based on the Atmel AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATMEGA16A achieves through puts approaching 1MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.

Features:-• High-performance, Low-power Atmel AVR 8-bit Microcontroller

• Advanced RISC Architecture

– 133 Powerful Instructions

–  32 × 8 General Purpose Working Registers + Peripheral Control Registers

–  Fully Static Operation

–  Up to 16MIPS Throughput at 16MHz

– On-chip 2-cycle Multiplier

• High Endurance Non-volatile Memory segments

– 16KBytes of In-System Self-programmable Flash program memory

– 512Bytes EEPROM

– 1KByte Internal SRAM

–  Write/Erase Cycles: 10,000 Flash/100,000 EEPROM

–  Data retention: 20 years at 85°C/100 years at 25°C(1)

– Optional Boot Code Section with Independent Lock Bits

• In-System Programming by On-chip Boot Program

• True Read-While-Write Operation

–  Programming Lock for Software Security

• JTAG (IEEE std. 1149.1 Compliant) Interface

– Boundary-scan Capabilities According to the JTAG Standard

– Extensive On-chip Debug Support Atmel-8151

– Programming of Flash, EEPROM, Fuses and Lock Bits through the JTAG Interface

• Peripheral Features

– Two 8-bit Timer/Counters with Separate Prescalers and Compare Modes

– One 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture            Mode

– Real Time Counter with Separate Oscillator

– Four PWM Channels

– 8-channel, 10-bit ADC

• 8 Single-ended Channels

• 7 Differential Channels in TQFP Package Only

• 2 Differential Channels with Programmable Gain at 1x, 10x, or 200x

– Byte-oriented Two-wire Serial Interface

– Programmable Serial USART

– Master/Slave SPI Serial Interface

– Programmable Watchdog Timer with On-chip Oscillator

– On-chip Analog Comparator

• Special Microcontroller Features

– Power-on Reset and Programmable Brown-out Detection

– Internal Calibrated RC Oscillator

– External and Internal Interrupt Sources

– Six Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, Standby, and  Extended Standby ‘

• I/O and Packages

̶  32 Programmable I/O Lines

̶  40-pin PDIP, 44-lead TQFP, and 44-pad QFN/MLF

• Operating Voltages

– 2.7 – 5.5V

• Speed Grades

– 0 – 16MHz

•   Power Consumption @ 1MHz, 3V, and 25°C

̶  Active: 0.6mA

̶  Idle Mode: 0.2mA

̶  Power-down Mode: < 1µA

Specification:-

ParametersValuesProgram Memory TypeFlashProgram Memory Size (KB)16CPU Speed (MIPS/DMIPS)16SRAM (B)1,024Data EEPROM/HEF (bytes)512Digital Communication Peripherals1-UART, 1-SPI, 1-I2CCapture/Compare/PWM Peripherals1 Input Capture, 1 CCP, 4PWMTimers2 x 8-bit, 1 x 16-bitNumber of Comparators1Temperature Range (°C)-40 to 85Operating Voltage Range (V)2.7 to 5.5Pin Count44 

Related Document:- 

 ATMEGA16A SMD Data Sheet* Product Images are shown for illustrative purposes only and may differ from actual product.